Rear output shaft seal

A4uj This video deals with changing the output seal on a transmission if you have a 4xit will take a bit more work. An output shaft seal , or what is also called an axle shaft seal , is the seal located between the driveshaft, and transmission panel. It is a circular disk designed to keep transmission oil from leaking onto the driveshaft.

The rear output seal on the transmission is a straightforward system. A transfer case output shaft is designed to transfer the motion of power and torque from the powertrain to the rear wheels of a four-wheel drive vehicle. The output shaft is built inside the transfer case with a drive shaft attached to it. And this is the housing of the output shaft seal area, it looks pretty grungy so I will clean it out later before reassembly. Here, I am using the seal puller to work out the old seal.

I found it best to gently work areas to evenly pull the seal. Timken Output Shaft Seal Front or Rear New Olds SaVana. Continued failure of this seal usually indicates a worn output shaft bushing. If so, there will be signs of the same wear on the driveshaft where it contacts the seal and bushing.

Your order may be eligible for Ship to Home, and shipping is free on all online orders of $35. For the last 30K or so (160K total), I have had a leaking rear output shaft seal on the transfer case. I replaced the seal several times ($each time) and it would stop for around 5K then start leaking again.

How do you change the rear output shaft seal leaking at rear of transmission only when running. Rear (8) Front (8) Passenger Side (1) Driver Side (4) Front, Inner (1). We have over lots of customer reviews on Chevy Output Shaft Seal to help you find exactly.

Get deals on automotive parts, truck parts and more. On axles that have the bolt-on deflector on the forward- rear output shaft bearing cage, the deflector must be removed and discarded. The new forward output sleeve will not assemble correctly to the new output seal with the bolt-on deflector in place. The odd thing is that the leak is not dead center of the rear , it’s more to the left (or right if you’re really having a bad day).

What you are probably experiencing is the failure of the output shaft seal (normally the driver’s side in the C5). Make sure not to scratch the shaft. Install the new seal and replace the flange and drive shaft.

Fill with new transfer case fluid and lower the vehicle.

Remove this with a pry bar or a seal puller. Ford F1Output Shaft Seal Review Fitment Notes to Ensure Proper Fit. Click to Enlarge (Read reviews) Our List Price: $ 12. I have replaced the output shaft seal xand it keeps leaking.

The shaft isn’t nicke has no excessive play. I have been very careful installing and have lubed more than needed. Ford Output Shaft Seal for T- AOD and CTransmissions. This direct replacement OEM Ford seal mounts on the tailhousing of a T- AOD or Ctransmission and prevents leaking from the driveshaft yoke. Ok, so i did my rear output shaft seal on the back of the trans today, and boy was it involved.

I took some pics so i figured id make a writeup on what you need and show how i did it.

You may notice a leak toward the rear of your transmission, be sure to check the shift selector shaft seal as well. The driveshaft output shaft seal can leak over time as the sealing lip wears. See our tech article on manual transmission selector shaft seal replacing.

Its a very common problem with the dodges. The transfer case takes any kind of ATF. Rear Output Shaft Seal Categories. AC Delco Output Shaft Seal - Rear. I noticed a tiny patch of oil appearing so climbed underneath to see if I could locate it.

Recently it seems to be getting worse. I had the seal changed three times over the last couple of years. Transfer case rebuild kits and parts at discount prices for Dana, Borg Warner and New Process units.

Fluid Leak From Transmission Output Shaft Seal on Audi AQuattro. A fluid leak may develop from the propeller shaft seal on the rear of the. A Auto shows you how to repair, fix, change or replace a rear transmission transfer case seal. This video is applicable to full-size Chevy Blazer, Chevy Truck, GMC Jimmy Or GMC Truck models.

Our technicians tell us that replacing the seal will commonly correct this concern. Locate the transfer case front output seal. Also I remember reading about some other seal inside the transfer case that could be leaking causing fluid to leak out of the output shaft seal.

The indicator is that the rear glass gets covered with the oil from the transfer case. The seal pictured is the rear transmission extension seal. This is the location where the slip joint of the drive shaft inserts into the tail shaft of the transmission. As for the pictures, the differences between the domestic counter parts and the nissan model are well documented in the forum.

If the rear output shaft seal is leaking, the yoke or flange (depending on U-joint type used) can be removed and the seal pulled out with a seal hook. Install a new seal , the yoke, and torque the yoke or flange nut to 1foot pounds.