How to replace tail light assembly

Locate the tail light assembly on the rear of your vehicle. They are located on each corner and light up when you apply your brakes or turn signal. First link is worthless, it simply takes you to an advertisement for lightbulbs. Second link is also worthless, it just takes you to ebay listing of tailight assemblies. Take your new tail light assembly and fit it slowly on the mount.

Make sure the tail light assembly fits along the edges of the mount smoothly. When the tail light assembly fits perfectly, remove it from the mount to connect the wires. Connect the wires of the new tail light assembly firmly so they will not loosen or detach.

DO NOT USE JB WELD to attach the light. You may need to remove the rear bumper to access the bolts. I have not had the rear lens out of a civic but I know on the accords you need to remove the bumper.

I think you have to download it. But it beats paying for it through the dealer. Not all damaged tail light covers need to be replaced. Depending on the extent of the problem and the price of the replacement parts, it may be cost effective to repair (as opposed to replace ) the tail light cover.

The two most common problems with tail light covers are cracks and broken seals. Phillips head screwdriver. Follow these steps to get the job done yourself.

Accidents happen and when they do you may need to replace your tail light assembly. In most cars, the tail light lens is part of a larger, sealed tail light assembly. If any part of the assembly is damage the entire tail light assembly must be replaced as a unit. Older cars might have a separately replaceable lens. A tail light assembly is an integral component of your lighting system that can enhance the visibility of your car or truck to drivers behind you.

Your tail light assembly must be repaired when the glass is broken or the bulb stops working. Four nuts hold the tail light assembly in place. Step – Remove the tail light and replace with new assembly. Once all of the nuts are remove unplug the tail light assembly. Gently pull the assembly up and away from the tail light area.

Bring the new light assembly up and into the correct area. Pinch in the small connector and pull out the light bulbs from the rear of the tail light assembly. Pull out the tail light bulbs.

Step - Remove the tail light assembly.

There are three 10mm bolts holding the rear tail light assembly in place. Carefully remove the bolts and set them aside. Swapping out the rear tail light assembly is much. Find great deals on eBay for rear tail light assembly. Its sleek black housing and durable plastic lens are made of the same quality as more expensive OEM parts.

Your order may be eligible for Ship to Home, and shipping is free on all online orders of $35. This guide will show you how to replace the tail light assembly in the 3rd generation Acura TL. Changing out a broken tail light assembly is actually not hard at all. Step – Unplug tail light sockets.

A cracked tail light lens can eventually allow water to get in which, in turn, can cause damage to your tail light and electrical system. The tail light lens of your Toyota Highlander is molded onto the tail light assembly. As a result, the entire tail light assembly will have to be replaced. The bulbs in your brake light or taillight assembly are held in place using a plug that holds the bulb.

We know our parts and products. The plug also screws into the light assembly. Swap out a faulty tail light on a Jeep Cherokee within minutes using these simple instructions.

Did you find it was just like the video when replace the light assembly. Broken tail light overview. During the repair, the tail light guard or cover will be remove usually by the multiple screws on the back of the unit. On each side of the inner tail light assembly , use your thumb to pull back and pop out the two metal tabs.

Gently remove the tail light assembly from the trunk lid. Replacing tail light assembly.

Undo the tabs, and remove the tail light assembly. Remove the taillight harness plug by pinching the locking tab and pulling the plug from the taillight plug housing. The taillight assembly is secured to the body by three nuts secured to the mounting studs.

It only takes a few minutes to remove the tail light assembly from your Dodge Dakota. The only tool you need is a torx screwdriver.